Table of Contents
Advertisement
CRANKCASE/CRANKSHAFT/TRANSMISSION
10-18
Install the collar onto
the
crankshaft.
Install the primary drive gear, bolt and washer.
Temporarily install the
clutch
outer guide, needle
bearing and clutch outer guide.
Attach the gear holder between
the
primary drive
and driven gear.
TOOL:
Gear holder
01124
-
001 0200 Not
available
in
U.S.A.
Tighten
the primary drive gear bolt to the specified
torque.
TORQUE:
64
N·m
(S.5 kgf·m,
47 Ibf.ftl
Install the remaining parts in the reverse order
of
removal.
NOTE:
Refer to Service Information
(page 10-11
for
installa-
tion
of
parts removed
to
perform
crankcase/trans-
mission service.
Start the engine and
check
for leaks
from
the
inspec-
tion hole.
PRIMARY
GEAR
- Quick Links:
- Torque Values
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
