Shock Linkage Installation - Honda CR 125R 2002 Sevice Manual

Press the needJe
Pack a new needle bearing with multi-purpose
bearing into the
shock arm with
the marked side
facing out.
Press the needle
bearings into
the
shock link with
the marked side
facing
OUI.
grease.
Press a new needle bea ring into the shock absorber
side pivot so that the needle bearing surface is
lower 2.0 - 2.2 mm (0.08 - 0.09 in) from the end of
the shock arm surface.
TOOLS:
Driver
Atta chment, 24
II
26 mm
Pilot, 19 mm
07749 - 0010000
07746 - 0010700
07746-0041400
SHOCK LINK NEEDLE BEARING
Drive the needle bearings out of the shock link from
the opposite side using a suit able tool.
Pack the new needle bea rings with mUlt i-purpose
grease.
Press the new needle bearings into the shock link
p ivot so tha t the needle bearing surface is lower
4.4 - 4.7 mm (0. 17 - 0.19 in) from the end of the
shock link surface.
TOOLS:
Driver
Attachment. 28
x
30 mm
Pilot. 20 mm
INSTALLATION
07749 - 0010000
07946 - 1870100
07746 - 0040500
Apply m u lti-purpose grease NLGI No.2 (molybdenum
disulfide additive) to the shock arm, sh ock li nk dust
sea l lips, collars and bearings.
NOTE:
Make sure th at the needle bearing railers are in
position before installing,
Nu mber of needle rollers :
Shock link: 32
Shock arm: shock link side: 32
swingarm side: 32
shock absorber side: 27
Install the dust seals, pivot col lar and side collars t o
the shock link.
Install the dust seals and washers to the shock arm
(shock link side).
Inst all the dust seals to the shock arm (swi n garm
sid e).
Install the pivot collar, side collars and dust seals to
the shock arm (shock absorber side).
REAR WHEEL/SUSPENSION
NEEDLE BEARING
j
2,0 - 2.2 mm
(0.08 - 0.09 in)
N EE DLE BEARINGS
--
4 .4 - 4.7 mm
(0.17- 0.19i
SIDE COLLAR DUST SEAL
\)0 --------
PIVOT
wee","
12-29