Drive/Driven Sprockets; Brake Fluid Level Inspection - Honda CR 125R 2002 Sevice Manual

MAINTENANCE
DRIVE/DRIVEN SPROCKETS
Never use
a
new
Inspecllhe dnve and driven sprocket teeth for wear
dnve cham on worn
or damage, replace if necessary.
Damaged Sprocket - - t - - Worn Sprocket
Teeth Teeth
sprockets
REPLACE
Normal Sprocket
Teeth
BRAKE FLUID
GOOD
CAUTION:
Do no t mix different types of fluid, as they are
not compatible with each other.
Do not allow foreign material to enter the system
when filling the reservoir.
Avoid spilling fluid on painted, plastic or rubber
parts. Place
a
rag over these parts whenever the
system is servicBd.
FLUID LEVEL INSPECTION
NOTE:
When the fluid level is low, check the brake pads for
wear (see next page). A low fluid level may be due
to wear afthe brake pads. If the brake pads are worn,
r-:;:;:~-;::=:-,--c,----­
the caliper piston is pushed out. and this accounts
for a low reservoir level. If the brake pads are not
worn and the fluid level is low, check the entire
system for leaks (see next pagel.
FRONT BRAKE :
Check the front brake fluid reservoir level through
the sight glass.
If the level is near the lower level mark, check the
brake pad wear (page 3-14).
REAR BRAKE :
Place the motorcycle on a level surface, and support
l':"~"'~:."'=-:::~~-.JILCIW'ER
it in an upright position.
Check the rear brake fluid reservoir level.
If the level is near the lower level mark, check the UPPER
brake pad wear (page 3-14).
FRONT:
Remove the screws, cover and diaphragm.
Fill the reservoir with DOT 4 brake fluid to the upper
level mark. Install the diaphragm and cover.
Tighten the screws to the specified torque.
TORQUE: 1 N·m
(0. 1
kgf·m.
0.7 IbMt)
Check the entire system for leaks.
MARK
REPLACE
3-13