IGNITION SYSTEM/ALTERNATOR
14-10
Hold the flywheel with the unive rsal holder then
remove the nut and washer.
TOOL:
Universal
holder
07725
-
0030000
Remove the flywheel using the flywheel
puller.
TOOL:
Flywheel puller
07733
-
0010000 or
07933 -
0010000
Remove the grommet, wood ruff key, bolts and
stator.
INSTALLATION
Install the woodruff key to the groove on the
crank-
shaft.
Install the stator and tighten the bolts
securely.
Install the grommet to the groove on the left crankcase.
Install the flywheel to the crankshaft by aligning the
groove on the flywheel
and
woodruff
key.
Install the washer and nut
.
Hold the flywheel
wit
h the special tool and tighten
the nut to the specified torque.
TOOL:
Universal
holder
07725
-
0030000
TORQUE:
54 N ·m (5.5
kgf.m,
40
Ibfoft)
NOT
E:
When you replaced the flywheel, stator o
r
leM, check
and
adjust
the ignition timing (see
below).