Steering Stem Removal - Honda CR 125R 2002 Sevice Manual

FRONT WHEEL/SUSPENSION/STEERING
Install the clutch lever bracket and holder with the CLUTCH
punch mark on the holder facing up.
Align the end of holder with the punch mark on the
handlebar.
Ti ghten the upper bolt fi rst, then the lower bolt.
TORQUE: 9 N·m 10.9 kgf.m, 6.5 Ibf.ft)
Connect the clutch cable.
Adjust the clutch lever free play (page 3-15),
Route the engine stop button wire. ENGINE
Install the engine stop bunon on the handlebar and
align the end of engine stop button holder wi t h the
punch mark on the handlebar.
Install and lighten the engine stop button screw with
the ground w i re .
TOROUE : 2 N·m (0.2 kgfom, 1.41bf·h l
Attach the engine stop button wire to t he handlebar
using the wire bands.
Route the number plate tab around the handlebar
cross bar as shown.
STEERING STEM
REMOVAL
Remove the number plate (page 2-3).
Remove the handlebar (page '1-24 ).
Remove the front wheel (page 1'-4).
Remove the fender bolts, collars and washers.
Remove the front fender and brake hose guide.
BRACKET
BunON
11-29