Image Send Settings; Fax Settings; Fax Default Settings; Dial Mode Setting - Sharp MX-2301N Operation Manual

Image Send Settings

Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings]
key to configure the settings.

Fax Settings

Fax Default Settings

The fax default settings can be configured to suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Default Settings] key to configure the settings.

Dial Mode Setting

This setting can only be activated in Canada, and
Taiwan.
Select the appropriate setting for your telephone line
type.
It is also possible to have the machine automatically
select the line type. Make sure that the telephone line is
connected to the machine and then touch the [Auto
Select] key. The machine will automatically select
"Tone" for a tone dial line or "Pulse" for a pulse dial line.
Auto Wake Up Print
When the [POWER] key (
switch is "on") and a fax is received, this function
automatically activates the machine and prints the fax.
When this function is disabled, received faxes are not
printed until the [POWER] key (
To enable this setting, select the checkbox
touch the [OK] key.

Pause Time Setting

This setting is used to select the duration of pauses that
are inserted in destination fax numbers.
If the [Pause] key is touched when dialling or storing a
fax number, a pause of 2* seconds is inserted.
The duration of each pause can be set to any number of
seconds from 1* to 15.
Specify the number with the
[OK] key. (To make the number change quickly, keep
your finger on the
* Note that in South Africa, the machine is normally set to
4 seconds.
Downloaded From ManualsPrinter.com Manuals
) is "off" (but the main power
) is switched "on".
and
keys and touch the
or key.)
Fax Dest. Confirmation Mode
This setting specifies whether or not a destination
verification message is displayed when sending a fax in
order to prevent accidental transmission to the wrong
destination. To enable this setting, select the checkbox
and touch the [OK] key.
Speaker Settings
Use these settings to set the sound heard from the
speaker for the Speaker, Ringer Volume, Line Monitor,
Fax Receive Complete Signal, Fax Send Complete
Signal, and Fax Communication Error Signal.
For the Fax Receive Complete Signal, the Fax Send
Complete Signal, and the Fax Communication Error
Signal, the Tone Pattern and Transmission Complete
Sound Time Setting can also be selected, and the
selected volume and pattern can be checked by
pressing the [Check on Setup Sounds] key.
Example: Fax Send Complete Signal screen
System Settings
Fax Send Complete Signal
Speaker Volume
Setting
No Sound
To change a setting, touch the appropriate key to
highlight the desired setting and touch the [OK] key.
7-155
SYSTEM SETTINGS
OK
1/2
Contents