Paper Does Not Feed From The Paper Tray; The Image On Paper Is Skewed; The Automatic Document Feeder Does Not Operate; Problems Related To Quality / Print Results - Sharp MX-2301N Operation Manual

Problem
The paper misfeeds.
Paper does not feed
from the paper tray.
The image on paper is
skewed.
The automatic
document feeder does
not operate.

PROBLEMS RELATED TO QUALITY / PRINT RESULTS

Problem
Lines appear in the
scanned image.
Downloaded From ManualsPrinter.com Manuals
Point to check
Is A5 (5-1/2" x 8-1/2") size paper
loaded?
Has the correct paper size been set?
Did you add paper to the bypass tray?
Is the paper loaded correctly in the
paper tray?
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in each mode
(copy, print, fax, Internet fax, and
document filing)?
Is too much paper loaded in the bypass
tray?
Are the bypass tray guides adjusted to
the width of the paper?
Are the original guides adjusted to the
width of the paper?
Have functions been disabled by the
administrator?
Point to check
Are the scanning areas of the document
glass or automatic document feeder
dirty?
Is the bypass feed roller dirty?
Load A5 (5-1/2" x 8-1/2") size paper in tray 1 (the first
tray), in tray 2 (the second tray), or in the bypass tray.
When loading A5 (5-1/2" x 8-1/2") size paper, place the
paper in the horizontal (A5R (5-1/2" x 8-1/2"R))
orientation.
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings"
When adding paper, remove any paper remaining in the
bypass tray, combine it with the paper to be added, and
reload as a single stack. If paper is added without
removing the remaining paper, a misfeed may result.
Set the guides to the size of the paper. Make sure the
height of the paper does not exceed the indicator line.
Check the Paper Tray Settings and see if checkmarks
appear in the checkboxes of each mode (Feeding
Approved Job). Functions without a checkmark cannot
be used for printing using that tray.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" >
Do not load more than the maximum number of sheets.
The maximum number of sheets varies depending on
the paper type setting. For more information, see
"SPECIFICATIONS" in the Safety Guide.
Adjust the bypass tray guides to the width of the paper.
Adjust the original guides to the width of the paper.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Clean the scanning areas of the document glass or
automatic document feeder.
☞
1. BEFORE USING THE MACHINE
"MAINTENANCE" (page 1-43)
Clean the surface of the bypass feed roller.
☞
1. BEFORE USING THE MACHINE
"MAINTENANCE" (page 1-43)
8-35
TROUBLESHOOTING
Solution
(Each mode)
Solution
Contents