Number Of Calls In Auto Reception; Auto Receive Reduce Setting; Print Style Setting - Sharp MX-2301N Operation Manual

Fax Receive Settings
The fax reception settings can be enabled or disabled to suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Receive Settings] key to configure the settings.

Number of Calls in Auto Reception

This setting is used to select the number of rings on
which the machine automatically receives a call and
begins fax reception in auto reception mode.
Specify the number with the
[OK] key. (To make the number change quickly, keep
your finger on the
The "Number of Calls in Auto Reception" that can be set
in each country are shown in the following table.
Country Differentiation Table
United Kingdom, France,
Germany, Sweden, Italy,
Spain, Netherlands,
Thailand, Hong Kong,
Saudi Arabia, South Africa
Australia, New Zealand
Singapore
Malaysia, India, Canada,
Taiwan
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.
Switching from Manual to
Automatic Reception
This Setting can only be activated in France.
When a fax is received in manual reception mode, you
have the machine automatically switch to auto reception.
The number of rings on which switching to auto reception
takes place can be set to any number from 1 to 9.
To enable this setting, select the [Switching to Automatic
Reception] checkbox
rings with the
change quickly, keep your finger on the
When finished, touch the [OK] key.
Downloaded From ManualsPrinter.com Manuals
keys and touch the
or key.)
The number of rings
0 to 9
2 to 4
0 to 3
0 to 15
and specify the number of
keys. (To make the number
Duplex Reception Setting
This used to have received faxes printed on both sides of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
To enable this setting, select the checkbox
touch the [OK] key.

Auto Receive Reduce Setting

When a fax is received that includes the sender's name
and number, the received image is slightly larger than
the standard size*. This setting is used to automatically
reduce the image to fit the standard size.
To enable this setting, select the checkbox
touch the [OK] key.
• If Auto Receive Reduce is disabled, the edges of
the image outside the standard size will be cut off.
However, the image will be clearer because it will
be printed at full size.
• Standard sizes are sizes such as A4 and B5
(8-1/2" x 11" and 8-1/2" x 5-1/2").

Print Style Setting

This setting determines the paper selection condition when
printing received faxes. Select one of the three conditions below.
Print Actual Size Cut off Disabled
The received fax image is printed at full size without
dividing it onto multiple sheets of paper. If the same
size of paper or larger paper is not loaded, the fax will
be received in memory and will not be printed until a
suitable size of paper is loaded.
However, if the received fax is longer than A3
(11" x 17") size, it will be automatically divided onto
multiple sheets of paper.
Print Actual Size Cut off Enabled
Each received image is printed at full size. If necessary,
key.)
the image is divided onto multiple sheets of paper.
Auto Size Select
Each received image is printed at full size when
possible. When not possible, the image is
automatically reduced before printing.
Touch the key of the desired paper selection condition
and touch the [OK] key.
7-160
SYSTEM SETTINGS
and
and
Contents