Sharp MX-2301N Operation Manual page 396

Fax
Special Modes
Program
Timer
3
Fax
Mode Switch
Job Detail
Settings
Memory TX
4
Direct TX
Auto Reception
Fax Memory:100%
(1)
Fax
Scan Size
Original
2-Sided
Booklet
5
2-Sided
Tablet
Press the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have
been scanned and then touch the [Read-End] key.
6
A beep will sound to indicate that scanning is finished.
The [Configure] key can be touched in the scan-end confirmation screen to change the exposure, resolution, scan size, and
send size. (However, when scanning each even-numbered page of the original, only the exposure can be changed.)
To cancel scanning...
Press the [STOP] key (
• Transmission is not possible at a size smaller than the original size.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
• The 2in1 function cannot be used when the original is other than A4, B5 or A5 (8-1/2" x 11" or 5-1/2" x 8-1/2") size.
• When the scan size of the original is specified by numerical values, this function cannot be used.
To cancel 2in1...
Touch the [2in1] key in the screen of step 3 so that it is not highlighted.
Downloaded From ManualsPrinter.com Manuals
Dual Page
Erase
Scan
Card Shot
2in1
(3)
Auto
Exposure
Standard
Resolution
Auto A4
Special Modes
Original
(2)
100%
Send Size
Auto A4 Auto
Image Orientation
(1)
).
Select 2in1.
OK
1/3
(1) Touch the [Job Detail Settings] key.
(2) Touch the [Special Modes] key.
☞
SPECIAL MODES
(3) Touch the [2in1] key so that it is
(4)
highlighted.
(4) Touch the [OK] key.
Display the original settings screen.
Address Book
(1) Touch the [Job Detail Settings] key.
Sub Address
Special Modes
(2) Touch the [Original] key.
File
Quick File
Specify the orientation in which the
OK
original is placed.
(1) Touch the appropriate [Image Orientation] key.
If this setting is not correct, a suitable image may not be
transmitted.
(2)
(2) Touch the [OK] key.
4-71
FACSIMILE
(page 4-60)
Contents