Network Settings; Ipv4 Settings; Ipv6 Settings - Sharp MX-2301N Operation Manual

Network Settings

Network settings are described below. Touch the [Network Settings] key and configure the settings.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
"TURNING THE POWER ON AND

IPv4 Settings

When using the machine on a TCP/IP network (IPv4),
use this setting to configure the IP address of the
machine.
System Settings
IPv4 Settings
IP Address
IP Subnet Mask
IP Gateway
Make sure that the [DHCP] checkbox is not selected
and then select each key, enter the required values with
the numeric keys, and touch the [OK] key.
To set the machine to obtain an IP address
automatically, select the [DHCP] checkbox
touch the [OK] key.
• To use the machine on a TCP/IP network, the
"Enable TCP/IP" (page 7-103) setting must also be
enabled.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
Downloaded From ManualsPrinter.com Manuals
OFF" (page 1-12) in "1. BEFORE USING THE MACHINE ".

IPv6 Settings

When using the machine on a TCP/IP (IPv6) network,
use this setting to configure the IP address of the
machine.
OK
DHCP
and
Select the [Enable IPv6 Protocol] checkbox (
Obtaining an IP address automatically
To set the machine to obtain an IP address
automatically, select the [DHCPv6] checkbox
touch the [OK] key.
When the settings are completed, the assigned state full
address and prefix length will be shown.
7-102
SYSTEM SETTINGS
System Settings
IPv6 Settings
Enable IPv6 Protocol
DHCPv6
Manual Address
System Settings
IPv6 Settings
Prefix Length
Default Gateway
Link-Local Address
System Settings
IPv6 Settings
Stateless Address 1
Stateless Address 2
Stateful Address
OK
1/3
OK
2/3
OK
3/3
).
and
Contents