Fax Send Settings; Auto Reduction Sending Setting; Quick On Line Sending; Printing Page Number At Receiver - Sharp MX-2301N Operation Manual

Fax Send Settings

The fax send settings are used to enable or disable certain fax functions to better suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Send Settings] key to configure the settings.

Auto Reduction Sending Setting

This setting is used to have the size of transmitted faxes
automatically reduced to match the size of the paper in
the receiving machine.
If the setting is disabled, faxes are sent at full size.
Because the size is not adjusted to match the size of the
printing paper, part of the received fax may be cut off.
To enable this setting, select the checkbox
touch the [OK] key.
Rotation Sending Setting
When transmitting an image that is one of the following
sizes, this function rotates the image counterclockwise
90 degrees.
A4, B5R, A5R, 8-1/2" x 11", 5-1/2" x 8-1/2"R, 16K
To use this setting, select the checkboxes
desired sizes and touch the [OK] key.
A4R and 8-1/2" x 11"R size images are not rotated.

Quick On Line Sending

When this setting is enabled, the machine starts transmitting a fax
as soon as the first page is scanned. Transmission takes place at
the same time as the remaining pages are being scanned.
If you disable this setting, transmission will not begin
until all pages have been scanned. Note that this setting
does not apply to manual transmission.
To enable this setting, select the checkbox
touch the [OK] key.

Printing Page Number at Receiver

This setting is used to add the page number to the top of
each fax page printed by the receiving machine.
To enable this setting, select the checkbox
touch the [OK] key.
Downloaded From ManualsPrinter.com Manuals
Date/Own Number Print Position
Setting
This setting determines the position of the date and sender
information printed at the top of faxes by the receiving
machine. To have the information printed outside the
transmitted document image, touch the [Outside the
Original Image] key. To have the information printed inside
and
the document image, touch [Inside the Original Image] key.
of the
and
and
7-158
SYSTEM SETTINGS
Contents