Sharp MX-2301N Operation Manual page 501

Specifying the original scan size (Specify using a standard size)
If the original is a non-standard size or you wish to change the scan size, touch the [Original] key to specify the original
size manually. Place the original in the document feeder tray or on the document glass and follow the steps below.
Select the mode and display the job detail settings screen.
(1) Touch the [Mode Switch] key and select the desired mode.
(2) Touch the [Job Detail Settings] key.
1
(3) Touch the [Original] key.
The automatically detected original size appears at the top of the [Original] key.
☞
JOB DETAIL SETTINGS
Scan
Scan Size
Original
Auto
2
2-Sided
Booklet
2-Sided
Tablet
Scan
Original
Auto
Manual
Manual
3
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 1000 mm (39-3/8") (the maximum height is 297 mm (11-5/8")).
☞
TRANSMITTABLE ORIGINAL SIZES
• To specify an Inch size for the scan size, touch the [AB
scan size.
Scan
Scan Size
Original
4
2-Sided
Booklet
2-Sided
Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
Downloaded From ManualsPrinter.com Manuals
(page 5-50)
100%
Send Size
A4 Auto
Image Orientation
AB Inch
A5 B5R
B4 216x340
A5R A4 A3 216x343
B5 A4R Long Size
Standard Size Size Input
(1)
100% Send Size
B5 Auto
Image Orientation
Touch the "Scan Size" key.
OK
Specify the scan size.
OK
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
(2)
(page 5-17)
Inch] key to highlight the [Inch] side and then specify the
Touch the [OK] key.
OK
5-53
SCANNER/INTERNET FAX
Contents