Entering Cartridges Through Standard Cap-Manual Mode - StorageTek 4410 Hardware Operator's Manual

Entering Cartridges through Standard CAP—Manual Mode
Use the appropriate enter command to enter cartridges into an automatic mode LSM
when a CAP is in manual mode. Each enter command lets you specify one CAP in one
LSM. Refer to the appropriate software manual for the command syntax and console
messages.
1. Type the enter command at the console.
The CAP Enter indicator on the CAP panel turns on.
A message appears on the console.
The CAP Locked indicator turns off.
The CAP door unlocks.
CAUTION:
EQUIPMENT DAMAGE. Make sure that the CAP LOCKED indicator is off
before you open the CAP.
WARNING:
PHYSICAL INJURY. To prevent contact with the robot and possible injury
to yourself, do not try to reach beyond the CAP into the LSM.
ATTENTION:
Avant d'ouvrir le CAP, vérifier que l'indicateur « CAP FERMÉ » n'est pas
allumé.
ATTENTION:
Pour éviter de heurter le robot et éviter d'être blessé, ne pas essayer
d'aller au-delà du CAP dans le LSM.
VORSICHT:
Prüfen, ob die Anzeige CAP LOCKED aus ist, bevor das CAP geöffnet
wird.
WARNUNG:
Um eine Berührung des Roboters und mögliche Verletzungen zu
verhindern, nicht versuchen, hinter das CAP in das LSM zu reichen.
ATTENZIONE:
Accertarsi che l'indicatore PANNELLO BLOCCATO sia spento prima di
aprire il pannello.
AVVERTENZA:
Per evitare il contatto con il robot e possibili lesioni, non tentare di
allungare le braccia nell'LSM oltre il CAP.
2. Open the CAP door by pressing the CAP latch
9206
(Figure 3-1 on page
Eleventh Edition
LSM Automatic Mode
3-4).
3-3