Firmware Upgrade; Outline - Konica Minolta bizhub C250P Service Manual

10. Firmware upgrade

10. Firmware upgrade

10.1 Outline

1
• There are two ways to update the Firmware: One is by directly connecting with the
Printer using the Compact Flash, and the other is by downloading over a network using
the Internet ISW.
NOTE
• When updating the Firmware card with the Ver. 43 or earlier to the Ver. 81 or later,
perform the following procedure without fail.
1. When the Serial Number Input screen is displayed after the Firmware was updated with
Main power being ON, enter the Serial Number with the following step.
[Tech. Rep. Mode] → [Serial Number]
See P.186
2. Perform the following setting.
[Tech. Rep. Mode] → [Version Upgrade] → [HDD Ver. Upgrade]
See P.189
3. Turn OFF the Main Power Switch and turn it ON again more than 10 seconds after.
4. Perform the following setting.
[Tech. Rep. Mode] → [Data Backup].
See P.194
5. Turn OFF the Main Power Switch and turn it ON again more than 10 seconds after.
56
Field Service Ver. 2.0 Mar. 2006