Konica Minolta bizhub C250P Service Manual page 273

17. Jig Soft
Step
1
Using the telephone line modem
Executing the initial transmission
1. Select Service Mode → CS Remote Care,
and select "Detail Setting" key.
2. Click "initial transmission" key on the right
bottom of the screen to start initial transmis-
sion.
3. When the machine is properly connected
with the Center, CS Remote Care setting
screen will be displayed.
NOTE
• The initial transmission key at the right
bottom of the screen will be displayed
12
only when the Center ID, the Device ID,
Telephone number of the Center and the
Device telephone number have been
input.
See P.239
232
Field Service Ver. 2.0 Mar. 2006
Procedure
Using E-mail
Receiving the initial connection E-mail mes-
sage
Sending the initial connection E-mail message
from the Center to the address of the Printer.
NOTE
• When receiving the initial connection E-
mail message from the Center while CS
Remote Care-related screen is being dis-
played, the current setting information
will be deleted, and CS Remote Care set-
ting will be displayed.
• For sending the initial connection E-mail,
see the manual for CS Remote Care Cen-
ter.
• Messages can be exchanged only
between the Center with initial connec-
tion and the Printer.
• The initial connection from the Center
will be carried out, and the E-mail
address of the Center will be stored in
the Printer.
• When the initial registration is complete,
the E-mail address of the Center will be
displayed by selecting Service Mode →
CS Remote Care → Detail Setting, Basic
Setting → E-Mail address.