Konica Minolta bizhub C250P Service Manual page 145

11. Other
[7]
[9]
104
4038F2C115DA
[8]
4038F2C116DA
[10]
[9]
4038F2C117DA
Field Service Ver. 2.0 Mar. 2006
4. Reinstall the Stopper [7].
NOTE
• When reinstalling the Stopper, use
care so that both ends of the Stop-
per will not open but stay parallel as
shown on the left.
Keep using the Stopper after once
stretched out may cause uneven
pitch or other image troubles.
5. Reinstall the Gear [8].
NOTE
• Make sure that the gear claw is fit
in.
6. Connect the Connector and the Flat
Cable.
NOTE
• Make sure the Harness is installed
along with the Harness guide.
7. Follow the same procedures to
install all the PH Units.
8. Install the Imaging Unit Guide Rail
[9].
NOTE
• Make sure that the two claws [10] at
rear end of the rail are fit in the
locating hole on the main unit.
9. Reinstall the Image Transfer Belt
Unit.
10. Reinstall the Front Cover.
11. Make skew adjustment of the PH
Unit.
NOTE
• When replacing the PH Unit, make
sure to conduct PH Unit skew
adjustment.