Konica Minolta bizhub C250P Service Manual page 272

Field Service Ver. 2.0 Mar. 2006
Step
1
Using the telephone line modem
Setting the Center ID
1. Select Service Mode → CS Remote Care, and click "Detail Setting" key.
6
2. Click Machine Setting → Center ID, and input the Center ID (five digits).
See P.239
Setting the Device ID
1. Select Service Mode → CS Remote Care, and click "Detail Setting" key.
7
2. Click Machine Setting → Device ID, and input Device ID (nine digits).
See P.239
Setting the telephone number of the Center
1. Select Service Mode → CS Remote Care,
and click "Detail Setting" key.
2. Click Machine Setting → Center Telephone
8
Number key.
3. Input the telephone number of the Center
using the 10-Keys Pad and P, T, W, - keys.
See P.239
Inputting the Device telephone number
1. Select Service Mode → CS Remote Care,
and click "Detail Setting" key.
2. Click Machine Setting → Device Telephone
9
Number key.
3. Input the Device telephone number using
the 10-Key Pad and P, T, W, - keys.
See P.239
Inputting the AT command for initializing the
modem
1. Select Service Mode → CS Remote Care →
and click "Detail Setting" key.
2. Click "AT Command" key.
3. Input AT Command.
NOTE
• Change this Command only when it is
necessary. (They do not need to be
10
changed in normal condition.)
• For details on AT Command, see the
manual for the modem.
See P.241
Setting the DIPSW for CS Remote Care
NOTE
11
• This setting is not normally necessary.
Take this step only when necessary in a
specific connecting condition.
Procedure
Using E-mail
Setting the Respond Timeout
1. Select Service Mode → CS Remote Care,
and click "Detail Setting" key.
2. Click "Respond Timeout" key and enter the
response timeout using the 10-Key Pad.
NOTE
• Under normal conditions, there is no
need to change the default setting.]
See P.239
Proceed to Step 10.
Setting the E-mail address
1. Select Service Mode → CS Remote Care,
and click "Server Set" key.
See P.241
2. Click "Server for RX" key, and set POP3
server address, POP3 Login name, POP3
password and POP3 port number.
3. Click "Receive" key, and set the E-Mail
address, Mail Check, Connection Time Out
and APOP Authentication.
4. Click "Send" key, and set the SMTP server
address, SMTP port number, Connection
Time Out, and APOP Authentication.
5. Click "TX/RX Test" key, and click Start key to
carry out a transmission/reception test. If it
fails to exchange messages, see the error
message to take necessary measure, and
try again.
Proceed to Step 12.
17. Jig Soft
231