Replacing The Tray 2 Pick-Up Roller - Konica Minolta bizhub C250P Service Manual

6. Periodical check
[17]
[20]
[18]
[22]
6.5.7

Replacing the Tray 2 Pick-up Roller

26
10. Remove the C-ring [15] and Bushing
[16], and remove the Shaft Assy [17].
[16]
[15]
4038F2C512DA
11. Remove two E-rings [18] and Bush-
ing [19], and remove the Tray 2 Pick-
up Roller fixing plate Assy [20].
[18]
[19]
4038F2C513DA
12. Remove the C-ring [21] and Tray 2
[21]
Feed Roller [22].
13. Select [Service Mode] → [Counter]
→ [Life] of the Jig software and clear
the count of [2nd.].
4036fs2596c0
1. Remove the Tray 2 Separation Roller
installation plate Assy.
• See the procedures 1 to 5 in "Tray 2
Separation Roller."
2. Remove the Tray 2 Right Rear
Cover.
See P.80
3. Disconnect the Connector [1].
[1]
4038F2C014DA
Field Service Ver. 2.0 Mar. 2006