System 2; Hdd; Image Controller Setting; Option Board Status - Konica Minolta bizhub C250P Service Manual

17. Jig Soft

17.10 System 2

17.10.1

HDD

Functions • To configure the printer as necessary when a hard disk is mounted.
Use • Use when the hard disk is mounted
Setting/Pro- • The default setting is "Unset"
cedure
NOTE
• After changing setting, make sure to turn off the Main Power Switch and turn it
on again more than 10 seconds after.
17.10.2

Image Controller Setting

Functions • To set the type of the controller.
• [Peripheral Mode] appears when [Others] is selected.
Use • When setting up the controller.
Setting/ Image Controller Setting
Procedure • Select the controller to be used.
"Controller 0"
Controller 1
Controller 2
Controller 3
Others
See the Setup Instructions for the Controller.
Peripheral Mode
• Select the operating mode of the Scanner.
Mode 1: Not use
Mode 2: Not use
Mode 3: Not use
17.10.3

Option Board Status

Functions • To set when the Optional Local Interface Kit is mounted.
Use • Use when setting up the Optional Local Interface Kit is mounted.
Setting/ • The default setting is "Unset."
Procedure
local I/F
NOTE
• After changing setting, make sure to turn off the Main Power Switch and turn it
on again more than 10 seconds after.
250
Set
: The standard controller is used.
: An external controller is used.
: An external controller is used.
: An external controller is used.
: An external controller is used.
:Set "Unset"
Field Service Ver. 2.0 Mar. 2006
"Unset"