List Output; Machine Management List; Adjustment List; State Confirmation - Konica Minolta bizhub C250P Service Manual

17. Jig Soft

17.12 List Output

17.12.1

Machine Management List

Functions • To produce an output of a list of setting values, adjustment values, Total Counter val-
ues, and others.
Use • At the end of setup or when a malfunction occurs.
Setting/ • Load the A4S plain paper to a paper source.
Procedure • Press the Start key, which will let the machine produce the list.
• The time-of-day and date will also be printed.
17.12.2

Adjustment List

Functions • To output the adjustment list for machine adjustment, process adjustment, etc. in
Service Mode.
Use • At the end of setup or when a malfunction occurs.
Setting/ • Load the A4S plain paper to a paper source.
Procedure • Press the Start key, which will let the machine produce the list.
• The time-of-day and date will also be printed.

17.13 State Confirmation

17.13.1

Sensor Check

Functions • To display the states of the input ports of sensors and switches when the machine
remains stationary.
Use • Used for troubleshooting when a malfunction or a misfeed occurs.
Setting/ • The operation of each of the switches and sensors can be checked on a real-time
Procedure basis.
• It can be checked as long as the 5-V power line remains intact even when a cover is
open.
A. Electrical Components Check Procedure Through Input Data Check
• When a paper misfeed occurs in the paper feed section of the machine, the Tray 2 Paper
Take-Up Sensor is considered to be responsible for it.
1. Remove the sheet of paper misfed.
2. From the Sensor Check List that follows, check the panel display of the Tray 2 Paper
Take-Up Sensor. For the Tray 2 Paper Take-Up Sensor, you check the data of "Take-Up"
of "Tray 2."
3. Call the Service mode to the screen.
4. Select [State Confirmation]
"Take-Up" under "Tray 2." For "Take-Up" under "Tray 2," select "1" on the left-hand side
of the screen.
5. Check that the data for "Take-Up" under "Tray 2" is "0" (sensor blocked).
6. Move the actuator to unblock the Tray 2 Paper Take-Up Sensor.
7. Check that the data for "Take-Up" under "Tray 2" changes from "0" to "1" on the screen.
8. If the input data is "0," change the sensor.
258
→
[Sensor Check] and then select the screen that contains
Field Service Ver. 2.0 Mar. 2006