Konica Minolta bizhub C250P Service Manual page 281

17. Jig Soft
(2) Date & Time Setting
Functions • To set the data and time-of-day
Use • Use to set or change the date and time-of-day.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Click [CS Remote Care].
3. Click [Detail Setting] to access Date & Time Setting.
4. Enter the date (month, day and year), time-of-day, and the time zone from the 10-
Key Pad.
5. Click [SET] to start the clock.
(3) RAM Clear
Functions • To clear the following data at the Center
ID Code, Primary Setting, Date/Time Input (Time Zone), Software SW Setting and AT
Command.
Use • To be used for setting CS Remote Care.
• To be used for reset the every data of the Center to default.
NOTE
• If RAM Clear is selected during transmission, RAM clear processing will be
implemented at the time the transmission is completed regardless of whether
it is done properly or not.
Setting/ • The default setting is "Unset."
Procedure
(4) Communication Log Print
Functions • To print out the Communication Log.
Use • Use to output and use the Communication Log.
Setting/ 1. Call the Service Mode on the screen.
Procedure 2. Click [CS Remote Care].
3. Click [Detail Setting] to access Communication Log Print.
4. Load Tray 1 or Bypass Tray with A4S or 8 1/2 x 11 paper.
5. Press Start key to print out the Communication Log.
(5) Software SW
Functions • To change the CS Remote Care settings.
Use • To change the settings for CS Remote Care as necessary.
Setting/
See P.233
Procedure
(6) Response Time Out
1
Functions • It sets the intervals for resending E-Mails when transmission error occurred.
• It can be set only when [E-Mail] is selected by System Setting.
Use • To use when changing the intervals for resending E-Mails when transmission error
occurred.
Setting/ • The default setting is 60 minute.
Procedure
240
Set
"60 minute" (10 to 1440)
Field Service Ver. 2.0 Mar. 2006
"Unset"