Field Service Ver. 1.0 Aug. 2006
4.
Firmware upgrade
4.1
Image processing board (IPB) firmware upgrading (magicolor
2530 DL)
NOTE
• The following upgrading procedure applies only to the magicolor 2530 DL.
4.1.1
Upgrading procedure
1. Connect the machine to the PC using an Ethernet cable. (The printer should be ON.)
2. In the Menu, select [SPECIAL PAGES] → [PRINT CONFIG PAGE] and execute the
function. Then, check the IP address [1] of the machine.
See P.86
3. Copy the firmware data and upgrading program to any directory on the PC.
4. Start the Command Prompt and go to the directory in which the firmware data is
stored.
5. Execute the "flashupdate" command to start the transfer of firmware data.
(The screen shown below indicates that the firmware data resides on the C drive.)
Data to be upgraded
Application
BOOT
XXX.XXX.XXX.XXX : IP address of the machine
******
: Firmware data file name
Command
flashupdate -r XXX.XXX.XXX.XXX ******.z
flashupdate -b XXX.XXX.XXX.XXX ******.flt
4. Firmware upgrade
[1]
A00VF2C584DA
4138fs2539e0
23