3. Periodical check
3.4
Maintenance Procedure (periodical check parts)
3.4.1
Replacing the tray 2 feed roller
A. Periodically replace parts/cycle
• Tray 2 feed roller: Every 300,000 prints
B. Procedure
1. Slide out Tray 2.
[2]
[1]
[1]
8
[3]
[2]
A011F2C603DA
[2]
A011F2C002DA
[1]
A011F2C501DA
Field Service Ver. 2.0 May 2007
2. Lock the media lift plate [1].
3. Snap off two C-clips [2] and remove
the bearing [3] at the front.
4. Snap off the C-clip [1] and remove
the feed roller [2].
NOTE
• When reinstalling the feed roller [1],
make sure that it is mounted in the
direction shown in the illustration
on the left.