Rep 9.9 Tray 2 Feeder Assembly/ Chute Assembly - Xerox Phaser 7500 Service Manual

REP 9.9 Tray 2 Feeder Assembly/ Chute Assembly

PL9.3.1/ PL9.3.2
Phaser 7500 Printer Service Manual
1. Remove the Regi Transport Assembly (REP 15.2,
Note
In the following step, if the Chute cannot be moved towards the rear, do not
force it to move because that is already the correct position.
2. Pull the tray out a few inches.
3. Slide the inner upper (when seen from the Tray Assembly insertion opening)
Chute towards the rear until it stops.
4. Release the 2 clamps that secure the harness that is connected to the Tray 2
Feeder Assembly and disconnect the wiring harness connectors.
5. Remove the 2 screws (silver, 8mm) that secure the Tray 1 Feeder Assembly to
the printer.
Service Parts Disassembly
page 8-174).
s7500-144
8-83