Rep 7.37 Feeder Stack Height Sensor - Xerox Phaser 4600 Service Manual

REP 7.37 Feeder Stack Height Sensor

Parts List on PL 8.20 Item 2
Removal
Use safe handling procedures when removing the module. Refer to
is heavy.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Separate the option feeder from the printer,
2. Remove the Tray.
3. Remove the Front Cover, REP 7.24.
4. Remove the Right Cover, REP 7.25.
5. Remove the Rear Cover, REP 7.27.
6. Remove the right side frame, REP
7. Remove the Take Away Clutch, REP
8. Remove the Feed Clutch, REP 8.41.
9. Remove the Feed Drive Assembly,
10. Remove the 2 screws that secure front frame rail to the chassis,
Figure 1 Remove the frame rail
11. Remove 10 (metal) and 4 (plastic) screws that secure the cover to the chassis,
4 Repairs and Adjustments
REP 7.37
WARNING
GP 15. The module
WARNING
GP 15.
7.34.
8.40.
REP 8.42.
Figure 1.
12. Remove the Feed Assembly,
13. Turn the assembly over and release the hook that secures the sensor to the Feed Assem-
bly, Figure 3.
Figure 2.
04/2016
4-52
Figure 2 Remove the top cover
REP 8.46.
Phaser 4600/4620/4622 Printer Service Manual
Revised