Quick Summary Of Important Procedures; To Turn The Machine On And Off; To Print The Config. Page (System Summary); To Print A Nozzle Check Pattern - Ricoh J012 Service Manual

Using the Operation Panel
1.2.3

QUICK SUMMARY OF IMPORTANT PROCEDURES

Here are some more details about how to use these keys. For more about correcting image
problems, please refer to section "4. Troubleshooting" of this Service Manual.
During the following procedures in the menu mode, the machine will automatically
leave the menu mode and return to standby mode if a key is not pressed for 60 sec.

To turn the machine on and off

1. To turn the machine on, press and hold the [Power] key for at least 1 sec.
The [Power] LED lights and "*Please Wait*" appears on the operation panel display until
the machine has warmed up. When the machine is ready for operation, the [Power] key
LED lights and the Copy mode display appears.
2. Press [Power] and hold for at least 1 sec. The power LED flashes slowly for a few
seconds and then goes off.

To print the Config. Page (System Summary)

1. [Menu]> "System Settings"
2. [ ] or [ ] > "Engine Settings?"> [Yes]
3. [ ] or [ ] > "2 List/Test Print?"> [Yes]> "Configuration Page?"
4. [Yes]> "Please Wait" displays as the report prints.

To print a Nozzle Check Pattern

1. [Menu]> "System Settings"
2. [ ] or [ ] > "Maintenance" > [Yes]> "Nozzle Check?"
3. [Yes]> "*Please Wait*" displays as the pattern prints.
4. [ ] or [ ] > "Nozzle Check" > [Yes]. The Nozzle Check pattern prints.
5. [Clear Modes] to return to the initial screen.
For more about how to use the Nozzle Check pattern to diagnose and correct
problems, see Section 4 "Troubleshooting."

To clean the print heads

Before cleaning the print heads always do a Nozzle Check to determine which color
is not printing. The print heads should be cleaned only if a problem exists.
J012/J013/J014
CÓPIA NÃO CONTROLADA
1-10
CÓPIA NÃO CONTROLADA
SM