Cleaning The Print Heads Before Storage - Ricoh J012 Service Manual

16. [No] [No]> Standby
The print head is flushed while the piezo element is rapidly switched on and off.
Once this operation is completed, Bit 1 resets to "0" automatically.
If you need to do this procedure again for another print head, you must repeat this
procedure and set Bit 1 to "1" again in the SP mode.
Drive cleaning cannot be performed if the ink tank of the selected print
head is almost empty.
4.5.9

CLEANING THE PRINT HEADS BEFORE STORAGE

Do this procedure to clean the print heads before storing the machine for one month or
longer.
This procedure should be done at the Repair Center before storing a machine until
it can be reused. This procedure is not intended for use at the job site by the
customer.
1. Turn the machine on.
2. [Clear Modes]> [107]> [Clear/Stop] for sec.
SYSTEM Ver.0.51
Service Menu
3. [ ] or [ ] > "ENGINE MAINT.> [Yes]
SP No.
1000
4. [ ] 4 times> "5000"> [Yes] 3 times
5. [ ] 7 times> "5007"> [Yes]
WASHING
5007
6. [Yes]
SM
CÓPIA NÃO CONTROLADA
4-55
CÓPIA NÃO CONTROLADA
Image Correction
J012/J013/J014