Ricoh J012 Service Manual page 27

Installation, Disassembly, and Adjustments
After installation, maintenance, or adjustment, always check the operation of the
machine to make sure that it is operating normally. This ensures that all shipping
materials, protective materials, wires and tags, metal brackets, etc., (attached to
protect the machine during shipping), have been removed and that no tools remain
inside the machine.
Never use your fingers to check moving parts that are causing spurious noise.
Never use your fingers to lubricate moving parts while the machine is operating.
Special Tools
Use only standard tools approved for machine maintenance.
For special adjustments, use only the special tools and lubricants described in the
service manual. Using tools incorrectly, or using tools that could damage parts,
could damage the machine or cause injuries.
During Maintenance
General
Before you begin a maintenance procedure always switch the machine off.
Disconnect the power plug from the power source.
Allow the machine to cool for at least 10 minutes.
Avoid touching the components inside the machine that are labeled as hot surfaces.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA