Ricoh J012 Service Manual page 222

Image Correction
WASHING
EXEC
7. Open the right front door, remove the print cartridges, replace them with the cleaning
cartridges, then close the right front door.
8. Confirm that "WASHING" and "EXEC" are displayed, then push [Yes].
9. When you see "OK?" push [Yes].
"RUNNING" displays while the cleaning sequence executes.
When cleaning is finished, the display returns to "WASHING" and "EXEC"
If the "Alert" lamp lights red, this indicates that an error has occurred. At
this step you cannot see the error displayed on the machine operation
panel.
Complete the procedure to return to standby mode, read the number of the
error displayed to determine the cause of the error.
10. [No] 3 times> "Engine Maint."
11. [ ] or [ ] > "End" > [Yes]
12. The machine switches off.
13. Remove the cleaning cartridges and store the machine.
The initial ink fill counter resets at the end of washing. The next time the ink
cartridges are installed and the machine is switched on, the initial filling
sequence will begin.
Do not install the ink cartridges and turn the machine on again after washing
until you are ready to use or service the machine again.
J012/J013/J014
CÓPIA NÃO CONTROLADA
4-56
CÓPIA NÃO CONTROLADA
SM