Do The Paper Type/Size Settings For Tray 2; Multi Bypass Tray J507; Installing The Multi Bypass Tray - Ricoh J012 Service Manual

Options
8. Make sure the top of the stack is perfectly flat. Do this if the top of the stack bends
upward:
9. Adjust the positions of the side fences and bottom fence.
10. Reattach the paper tray cover.
11. Slowly insert the paper tray into the machine.
12. Make sure that the paper tray is correctly inserted.

Do the Paper Type/Size Settings for Tray 2

1. [Menu]> "System Settings?"
2. [ ] or [ ] > "Tray Paper Setting?"> [Yes]> "Tray1?"
3. [ ] or [ ] > "Tray2?"> [Yes]> "Paper Type?"> [Yes]> "Plain Paper?"
4. [ ] or [ ] > Select the type of paper that will be loaded in Tray 2
5. [Yes] > "Tray Paper Setting?"> [Yes] "Tray2?"> [Yes]> "Paper Type?"
6. [ ] or [ ] > "Paper Size?> [Yes]
7. [ ] or [ ] > Select the size of paper that will be loaded in Tray 2
8. [Yes] > "Tray Paper Setting?"
9. [Clear Modes> Standby
10. Cycle the machine off/on.
1.4.2

MULTI BYPASS TRAY J507

The multi-bypass tray is an option that can be installed on any J012, J013, or J014 machine.

Installing the Multi Bypass Tray

1. Make sure that the machine is switched off and disconnected from its power source.
2. Remove the multi-bypass tray from its box.
3. Remove all the orange shipping tape and plastic from the bypass tray.
4. Push the multi-bypass tray into the back of the machine as shown unit it clicks.
5. Pull out the extension of the multi-bypass tray.
6. Load paper in the tray with the print side facing up.
J012/J013/J014
CÓPIA NÃO CONTROLADA
1-30
CÓPIA NÃO CONTROLADA
SM