Set Maintenance Method; Set Threshold For Venting During Printing - Ricoh J012 Service Manual

Set Maintenance Method

SP2115 to SP2118 are for future use and not used at the present time.
2115 TH:ALM:TM1:MNT1
2116 TH:ALM:TM1:MNT2
2117 TH:ALM:TM1:MNT3
2118 TH:ALM:TM1:MNT4
Use this SP to select the type of maintenance that will be executed before the first
print job begins after the idle time threshold has elapsed.
1
*
Air venting/filling is done if Bit 1 of SW8-3 is ON.
2
* Print head refreshing (flushing) is done if Bit 2 of SW8-3 is ON.
[0 to 65535/0/1/hours.]
Note: These SP codes are not available for this machine.

Set Threshold for Venting During Printing

SP2200 to SP2202 are for future use and not used at the present time.
2200 TH:PRG:HUMI1
2201 TH:PRG:HUMI2
Use this SP to set the threshold value in the humidity table switches to the table
for air venting during printing.
SP2200: Looks up the low humidity table (35%).
SP2201: Looks up the high humidity table (65%).
o
[0 to 100/0/1/ C.]
SM
CÓPIA NÃO CONTROLADA
After Time 1 Alarm (SP2111): Venting
After Time 2 Alarm (SP2112): Cleaning
After Time 3 Alarm (SP2113): Cleaning *
After Time 4 Alarm (SP2114): Cleaning *
35% Humidity
65% Humidity
5-65
CÓPIA NÃO CONTROLADA
SP Mode Service Tables
1
2
J012/J013/J014