Ricoh J012 Service Manual page 208

SC Error Codes
Code
00B6 No Phase 4 signal detected within 25 sec. after CM/JM exchange.
00B8 Remote machine disconnected after local machine sent DCS signal in V.34.
00BA No correct signal received after local machine sent DTC signal in V.34.
00BB Every time our side received DIS signal after sending DTC in V.34.
00BC Modem was not ready within 10 sec. after entering primary channel in V.34.
00BD No correct V.21 or JM signal detection after FSK frequency detection.
00BE No document to poll on remote machine after V8 handshake.
00BF Capability mismatch after V8 handshake.
00C1 At Phase D TX unit cut out EOP 3 times but received no answer from RX unit.
00C2 Remote side disconnect after sending out V.8 CM signal.
00C4 After MPS signal received, data was not MCF, RTN, PIP, PIN, RTP, or DCN.
00C5 DCN signal received after MPS signal sent.
00C9 MPS was sent 3 times at Phase D but there was no answer from RX unit.
After EOP signal was sent, the data received was not MCF, RTN, PIP, PIN,
00CA
PRI-EOP, or DCN.
00CB After EOP signal was sent, the data received had no DCN signal.
After EOM signal was sent, the data received was not MCF, RTN, PIP, PIN,
00CC
RTP, or DCN.
00CD TX units sent EOM 3 times at Phase D, but no answer was received.
00CE TX unit send EOM at Phase D but received DCN.
00CF Incorrect signal received after sending DTC signal for V.34 polling.
00D0 Received ERR signal after sending EOR_NULL.
00D1 Received incorrect response after sending PPS_EOP signal in V.34.
J012/J013/J014
CÓPIA NÃO CONTROLADA
Possible Cause
4-42
CÓPIA NÃO CONTROLADA
SM