Connect The Nib - Ricoh J012 Service Manual

Options
2. Make sure that the machine is switched off and disconnected from its power source.
3. Lift the connector cover.
4. Before you touch the network interface board, touch a metal surface to ground any
static charge.
Handle the network interface board carefully.
5. Slowly push the NIB into the machine until it stops.
6. [Power]> Cycle the machine off/on
7. [Menu]> "System Settings?"
8. [ ] or [ ] > "Network Settings?."
If you see "Network Settings" this means the NIB is installed correctly.
For more about how to connect the Ethernet cable and perform the network settings, see the
"Quick Installation Guide."

Connect the NIB

Be sure to install the necessary network equipment (a hub, for example) before connecting
the Ethernet cable to the machine.
J012/J013/J014
CÓPIA NÃO CONTROLADA
1-32
CÓPIA NÃO CONTROLADA
SM