Set Charge Area 2 - Ricoh J012 Service Manual

Set Charge Area 2

1235 CHG:AREA2:OPH
Use this SP to set the size of the MIDL area of transparencies (OHP).
Do this setting when you want to adjust pitch amount of the charge applied to the
MIDL area of transparencies for printing. The MIDL area is shown below.
[0 to 0xffff ffff/0/1/---]
1236 CHG:AREA2:F
Use this SP to set the size of the MIDL on the 1st side of any paper except
transparencies (OHP).
Do this setting when you want to adjust pitch amount of the charge applied to the
MIDL area on the 2nd side of any paper other than transparencies. The MIDL
area is shown below.
[0 to 0xffff ffff/0/1/---]
1237 CHG:AREA2:B
Use this SP to set the size of the MIDL on the 2nd side of any paper except
transparencies (OHP) for duplex printing. Do this setting when you want to adjust
pitch amount of the charge applied to the MIDL area on the 2nd side of any paper
other than transparencies for duplex printing. The MIDL area is shown below.
[0 to 0xffff ffff/0/1/---]
SM
CÓPIA NÃO CONTROLADA
Set Charge of Area 2 for MIDL: OHP
Set Charge of Area 2 for MIDL: Simplex: Any Other Than
OHP
Set Charge of Area 2 for LE/TE: Duplex: Any Other Than
OHP
5-59
CÓPIA NÃO CONTROLADA
SP Mode Service Tables
J012/J013/J014