Ricoh J012 Service Manual page 114

Common Procedures
1. Disconnect the harness [3].
2. Disconnect the ground wire [1] ( x1).
3. At the right rear corner of the machine, disconnect the ground wire [2] ( x1).
4. Lower the scanner unit.
5. At the back of the machine, remove the USB connection cover [1] ( x1).
6. Pull out the USB connector [2].
7. If screw [1] is loose, tighten it.
8. While supporting the upright scanner unit with one hand to prevent it from falling back,
raise the latch [2] to disconnect the support strap.
J012/J013/J014
CÓPIA NÃO CONTROLADA
3-26
CÓPIA NÃO CONTROLADA
SM