Table of Contents
Advertisement
1.3.7
CONNECT THE POWER CORD
Always connect the printer to a proper power source.
Do not share the printer power source with another electrical device or appliance.
Connect the power cord directly into the power source. Never use an extension
cord.
Never attempt to modify the power cord in any way.
Never put heavy objects on the power cord.
Make sure that the area around the power source is free of unwanted obstacles so
you can disconnect the power cord quickly in case of an emergency.
Make sure the power cord is not coiled or wrapped around any object such as a
table or desk leg.
Never coil the power cord around itself to make it shorter. This can cause the cord
to overheat and start a fire.
Never handle the power cord with wet hands.
1.
Remove the orange tape from around the power cord.
2.
Plug the power cord into the power source.
3.
Make sure that the power source is properly grounded.
1.3.8
COMPLETE THE INSTALLATION
Power On
1.
Press the [Power] key.
The printer starts pumping ink into the ink tanks.
Two alternating messages are displayed with a progress bar to keep you informed
about the progress of ink filling.
Filling the ink tanks requires about 6 to 10 minutes.
Do not use the printer or touch any key on the operation panel until you see the
"Ready" message on the operation panel display.
As soon as the "Ready" message is displayed, the Power lamp lights and remains
on.
Never switch off the printer or disconnect the power cord while the tanks in
the print head are being filled for the first time.
If you accidentally turn the printer off while the ink tanks are filling, or if
there is a power failure the printer will dump the ink and empty the tanks.
The next time the printer is turned on, it will display the 'ink out' alert.
SM
CÓPIA NÃO CONTROLADA
1-23
CÓPIA NÃO CONTROLADA
Installation Procedure
J012/J013/J014
Hide quick links:
Advertisement
Table of Contents
