Facsimile Errors; Communication (Rx) - Ricoh J012 Service Manual

4.4.5

FACSIMILE ERRORS

Here is a list of errors that may occur during fax sending and receiving.

Communication (RX)

Code
0001 Manual RX mode, no G3 signal received within 35 sec.
0003 Received DIS after sending DIS signal.
0004 Received DCN after sending DTC signal.
0009 No signal received within 35 sec. in manual polling mode.
0010 Received DCN signal after sending DTC signal during polling RX.
0011 Cannot receive correct response after sending three DTC signals.
Remote/local password mismatch during polling RX, or no local file to be
0012
polled.
0013 No carrier received within 6 sec. after sending CFR in data phase C.
0014 No T.30 signal received after sending FTT signal.
0016 Received DCN signal after sending PTT signal.
0017 No response received from remote machine after sending xxx_EOM signal.
0018 Nothing detected within 6 sec after sending FTT command
0019 Received DCN signal after sending CFR signal
001A No power on line over 6 sec. within phase C before a corrected ECM frame.
001D Detected flag but nothing after CFR.
001E Timeout in V.17 ECM RX phase C
0x1F Machine cannot detect V.21 or V.8 signal with 35 sec.
Cannot correct frame within 6 sec., a decoding line over 6 sec in non-ECM
0020
mode..
SM
CÓPIA NÃO CONTROLADA
Possible Cause
4-37
CÓPIA NÃO CONTROLADA
SC Error Codes
J012/J013/J014