Scanner Unit Sensor - Ricoh J012 Service Manual

Sensors
3.8.6

SCANNER UNIT SENSOR

Preparation:
Remove platen or ADF. (
Raise the scanner unit to full upright. (
Remove: (1) paper cassette, (2) paper output tray, (3) right front cover, (4) right cover,(5)
right inner cover, (6) front cover (
The scanner unit sensor is inside the front cover.
1. Remove the screws of the sensor cover [1] ( x2).
2. Push the scanner unit sensor [2] to the right to slide it off its pegs (x2).
Reassembly
Make sure the sensor is mounted on both pegs before you try to reattach the cover.
The cover will not fit over the sensor until the sensor is set correctly on both pegs.
J012/J013/J014
CÓPIA NÃO CONTROLADA
3.2.4, 3.2.5)
3.2.7)
3.2.8, 3.2.9, 3.2.10, 3.2.11, 3.2.13)
3-58
CÓPIA NÃO CONTROLADA
SM