Communication (Tx) - Ricoh J012 Service Manual

SC Error Codes
Code
Cannot detect any control channel signal within 60 seconds after detect silence
0065
in phase D.
0066 No T.30 signal or carrier received after CFR was sent in V.34.
0069 Paper size mismatch after DCS signal received.
0070 Operator press [Stop] key during receiving.
0071 Memory became full during receiving.

Communication (TX)

Code
0080 No G3 signal detected within 35 sec. in Phase B as specified by ITU-T.
0081 Received DTC signal in TX phase.
0082 TX unit received a signal other than DIS or DTC, or DCN in Phase B.
0083 FSK signal detected no signal received within 35 sec.
0084 Detected DCN signal in Phase B.
0085 TX unit sent DCS 3 times but each send met DIS/DTC response.
0086 After DCS sent response signal was other than DTC, DIS, FTT, DCN or CFR.
0087 Training attempt failed because machine speed could not adjust to low speed.
0088 Received DCN signal after DCS signal sent.
Remote machine has no mailbox function or mailbox function is not
0089
compatible.
008B Local RX machine received DIS protocol but protocol not compatible.
008C Local machine memory insufficient for starting relay sending.
008D Received RX machine DIS protocol but remote machine could not receive
J012/J013/J014
CÓPIA NÃO CONTROLADA
Possible Cause
Possible Cause
4-40
CÓPIA NÃO CONTROLADA
SM