Subaru 2002 IMPREZA Service Manual page 583

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
Step
2 CHECK FAILURE CAUSE OF P0131 or
P0132.
Inspect the DTC P0131 or P0132 using "17.
List of Diagnostic Trouble Code (DTC)". <Ref.
to EN-83, List of Diagnostic Trouble Code
(DTC).>
3 CHECK REAR OXYGEN SENSOR DATA.
1)Warm-up the engine until engine coolant
temperature is above 70°C (158°F), and keep
the engine speed at 2,000 rpm to 3,000 rpm for
2 minutes.
2)Read the data of rear oxygen sensor signal
using Subaru Select Monitor or OBD-II general
scan tool.
NOTE:
•Subaru Select Monitor
For detailed operation procedure, refer to the
"READ CURRENT DATA SHOWN ON DIS-
PLAY FOR ENGINE". <Ref. to EN-34, Subaru
Select Monitor.>
•OBD-II general scan tool
For detailed operation procedures, refer to the
OBD-II General Scan Tool Instruction Manual.
4 CHECK REAR OXYGEN SENSOR DATA.
Read the data of rear oxygen sensor signal
using Subaru Select Monitor or OBD-II general
scan tool.
1)Keep the engine speed at 4,500 rpm for 5
seconds.
2)Release the accelerator quickly and idle the
engine for 10 seconds.
3)Repeat this cycle for three times.
5 CHECK HARNESS BETWEEN ECM AND
REAR OXYGEN SENSOR CONNECTOR.
1)Turn the ignition switch to OFF.
2)Disconnect the connectors from ECM and
rear oxygen sensor.
3)Measure the resistance of harness between
ECM and rear oxygen sensor connector.
Connector & terminal
(B136) No. 16 — (B19) No. 3:
6 CHECK GROUND CIRCUIT ON ECM.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from ECM.
3)Measure the resistance of harness between
ECM connector and chassis ground.
Connector & terminal
(B136) No. 21 — Chassis ground:
Check
Is the failure cause of P0131 or
P0132 in the fuel system?
Does the value fluctuate?
Is the value fixed between 0.2
and 0.4 V?
Is the resistance more than 3
Ω?
Is the resistance less than 5
Ω?
EN-151
ENGINE (DIAGNOSTICS)
Yes
Check the fuel Go to step 3.
system.
NOTE:
In this case, it is
not necessary to
inspect DTC
P0136.
Go to step 7. Go to step 4.
Go to step 5. Replace the rear
oxygen sensor.
<Ref. to FU-47,
Front Oxygen (A/
F) Sensor.>
Repair the open Go to step 6.
circuit in harness
between ECM and
rear oxygen sen-
sor connector.
Go to step 8. Go to step 7.
No