Table of Contents
Advertisement
Figure 7
Tools supplied by service personnel
Null modem cable
The following tools should be supplied by service personnel:
•
Scissors or pocket knife - A sharp cutting edge (scissors or knife
blade) is required to cut protective strapping when unpacking
replacement CRUs.
•
Flat-tip and cross-tip (Phillips) screwdrivers - Screwdrivers are
required to remove, replace, adjust, or tighten CRUs, chassis, or
cabinet components.
®
•
T10 Torx
tool - The tool is required to rack-mount products or to
remove, replace, adjust, or tighten chassis or cabinet components.
•
ESD grounding cable and wrist strap - An ESD wrist strap is
required when working with ESD-sensitive CRUs, including
optical transceivers.
•
Maintenance terminal - A desktop or notebook PC is required to
configure product network addresses and acquire event log
information through the maintenance port. The PC must have:
— The Microsoft® Windows® 98, Windows® 2000, Windows®
2003, Windows® XP, or Windows® ME operating system
installed.
— RS-232 serial communication software (such as ProComm
Plus™ or HyperTerminal) installed. HyperTerminal is
provided with Windows operating systems.
•
Fiber-optic cleaning kit - The kit contains tools and instructions
to clean fiber-optic cables, connectors, loopback plugs, and
protective plugs.
Chapter 1: General information
15
Advertisement
Table of Contents
