Table of Contents
Advertisement
•
One product is installed on a dedicated LAN, network
information (IP address, subnet mask, and gateway address) does
not require change.
•
Multiple products are installed or a public LAN segment is used,
network information must be changed to conform to the LAN
addressing scheme.
Perform this procedure to change product network information.
1. Select Switch and Network from the Configure menu at any view.
The Network View displays
Network View
Figure 15
a. At the IP Address field, type the new value as specified by the
network administrator (default is 10.1.1.10).
b. At the Subnet Mask field, type the new value as specified by
the network administrator (default is 255.0.0.0).
c. At the Gateway Address field, type the new value as specified
by the network administrator (default is 0.0.0.0).
2. Click OK to save and activate changes. An acknowledgement
message displays, indicating the browser PC must be directed to
the new IP address.
3. Update the address resolution protocol (ARP) table for the
browser PC.
(Figure
15).
Chapter 2: Installation tasks
33
Advertisement
Table of Contents
