Table of Contents
Advertisement
Customer-replaceable unit: SFP optical transceiver
Tools required
Removal
202
SAN32M-2 Installation and Service Manual
•
Touch the product chassis once before performing a procedure,
and once each minute during the procedure.
•
Store ESD-sensitive parts in antistatic packaging.
The small form factor pluggable optical transceiver is a concurrent
part that is removed and replaced while the product is powered on
and operational.
There are ESD precautions for the part.
Refer to
Chapter 6, Illustrated parts breakdown
and part numbers.
The following tools are required:
•
Protective cap (provided with the fiber-optic jumper cable).
•
Loopback plug (provided with the product).
•
Fiber-optic cleaning kit.
•
ESD grounding cable and wrist strap.
A 5/16-inch door tool may be used for some procedures.
To remove an SFP optical transceiver:
1. Notify the customer that the port with the defective transceiver
will be blocked. Ensure the customer's system administrator sets
any attached device offline.
2. If the product is not rack-mounted, go to
rack-mounted, perform one of the following:
— If the product is installed in an equipment cabinet, insert the
5/16-inch door tool into the socket hole at the right top of the
door (front or rear). Turn the tool counter- clockwise to unlock
and open the door.
— If the product is installed in a customer-supplied equipment
cabinet, unlock and open the cabinet door (front or rear) as
directed by the customer representative.
3. Identify the defective port transceiver from:
— An illuminated amber LED adjacent to the port.
for the part locations
step
3. If the product is
Advertisement
Table of Contents
