IBM TotalStorage SAN32M-2 Installation And Service Manual page 124

Event codes versus maintenance action (Continued)
Table 7
Event
code Explanation
310 Cooling fan propeller recovered.
311 Cooling fan propeller recovered.
312 Cooling fan propeller recovered.
313 Cooling fan propeller recovered.
314 Cooling fan propeller recovered.
315 Cooling fan propeller recovered.
370 Cooling fan status polling temporarily disabled.
400 Power-up diagnostic failure.
410 Switch reset.
411 Firmware fault.
412 CTP watchdog timer reset.
421 Firmware download complete.
423 CTP firmware download initiated.
426 Multiple ECC single-bit errors occurred.
433 Non-recoverable Ethernet fault.
440 Embedded port hardware failed.
442 Embedded port anomaly detected.
445 ASIC detected a system anomaly.
453 New feature key installed.
506 Fibre Channel port failure.
507 Loopback diagnostics port failure.
508 Fibre Channel port anomaly detected.
510 Optical transceiver hot-insertion initiated.
512 Optical transceiver nonfatal error.
98
SAN32M-2 Installation and Service Manual
Action
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
Go to MAP 0400.
Go to MAP 0200.
No action required.
Go to MAP 0200.
Go to Collect maintenance data. (EFCM Basic) or
Collect maintenance data (Element Manager).
No action required.
No action required.
Go to MAP 0400.
Go to MAP 0400.
Go to MAP 0400.
No action required.
No action required.
No action required.
Go to MAP 0500.
Go to MAP 0500.
No action required.
No action required.
Go to MAP 0500.