Table of Contents
Advertisement
132
SAN32M-2 Installation and Service Manual
18
As indicated by event code 507, a port failed a loopback test. Reset
the failed port.
a. At the EFCM Basic Edition interface:
1. Select Ports and Reset from the Maintenance menu at any
view. The Reset View displays.
2. If necessary, use the vertical scroll bar to display the
information row for the port.
3. Select (click) the check box in the Reset column.
4. Click OK. The port resets.
b. At the Element Manager:
1. At the Hardware View, right-click the port. A pop-up menu
appears.
2. Select Reset Port. The message This operation will cause
a link reset to be sent to the attached device displays.
3. Click OK. The port resets.
c. Perform an external loopback test for the reset port. Refer to
External loopback test
loopback test
(Element Manager).
Was the maintenance action successful?
NO
YES
↓
The product port is operational. Exit MAP.
Go to
step
17.
19
A message appeared in the Link Incident Log or an event code 581,
582, 583, 584, 585, or 586 was observed at the console of an OSI
server attached to the product reporting the problem. Clear the link
incident (Element Manager only).
a. At the Hardware View, right-click the port. A pop-up menu
appears.
b. Select Clear Link Incident Alert(s). The Clear Link Incident
Alert(s) dialog box displays.
(EFCM Basic Edition) or
External
Advertisement
Table of Contents
