Enable EFCM Basic Edition and Telnet access
Configure, enable, and test e-mail notification
Figure 44
Perform this procedure to enable EFCM Basic Edition interface and
Telnet access through the maintenance port. To enable the functions:
1. To enable the EFCM Basic Edition interface, select Enable Web
Server from the Configure menu at any view. A check mark
appears when the interface is enabled, and the menu closes.
2. To enable Telnet access, select Enable Telnet from the Configure
menu at any view. A check mark appears when access is enabled,
and the menu closes.
Perform this procedure to configure, enable, and test e-mail and
simple mail transfer protocol (SMTP) addresses to receive event
notifications. Configuration and test are performed at the SAN
management application. E-mail notification is enabled at the
Element Manager application. To perform the procedures:
1. Minimize the Element Manager application and return to the
SAN management application.
2. At the SANavigator or EFCM main window, select Event
Notification and Email from the Monitor menu. The Email Event
Notification Setup dialog box displays
Email Event Notification Setup dialog box
3. To enable e-mail transmission to configured addresses, click the
Enable Email Event Notification check box. A check mark appears
when transmission is enabled.
(Figure
44).
Chapter 2: Installation tasks
83