Table of Contents
Advertisement
Install or upgrade software
f. At the Discover Setup dialog box, click OK. Switch-to-
management server communication is restored and the
procedure is complete.
8. Change the switch IP address and restart the management server
session as follows:
a. A grey square with a yellow exclamation mark appears
adjacent to the icon representing the reset switch, indicating
switch is not communicating with the management server.
a. Delete the icon representing the reset switch. At the SAN
management application, select Setup from the Discover menu.
The Discover Setup dialog box displays
b. Select (highlight) the entry representing the reset switch in the
Available Addresses window and click Remove.
c. At the Discover Setup dialog box, click OK. The switch is no
longer defined to the management server.
d. Change the switch IP address through the maintenance port.
Refer to
Task 5: Configure product network information (optional)
for instructions.
e. Identify the switch to the SAN management application. Refer
to
Task 12: Configure the product to the management application
instructions.
The firmware version shipped with the product is provided on the
System Version XX.YY.ZZ CD-ROM. The SAN management
application (software) shipped with the product is provided on the
EFC Management Applications CD-ROM. Subsequent (upgrade)
firmware and software versions are provided to customers through
IBM.
NOTE: When upgrading firmware or software, follow all procedural
information contained in release notes or engineering change (EC)
instructions that accompany the version. Such information supplements
information provided in this general procedure.
To obtain the latest level of firmware, go to:
http://www.ibm.com/servers/storage/support/san/index.html .
Locate the link for this switch and then select the link for
downloading firmware.
(Figure
66).
Chapter 4: Repair information
for
197
Advertisement
Table of Contents
