Backup And Restore Configuration Dialog Box - IBM TotalStorage SAN32M-2 Installation And Service Manual

Back up
configuration
Figure 64
Restore
configuration
Reset
configuration data
194
SAN32M-2 Installation and Service Manual
To back up the switch configuration file to the management server:
1. At the Element Manager application (management server), select
Backup & Restore Configuration from the Maintenance menu. The
Backup and Restore Configuration dialog box displays

Backup and Restore Configuration dialog box

2. Click Backup. An Information dialog box displays, indicating the
backup was initiated.
3. Click OK to complete the backup and close the dialog box.
To restore the switch configuration file from the management server:
1. Notify the customer the switch is to be set offline. Ensure the
customer's system administrator quiesces Fibre Channel frame
traffic through the switch and sets attached FC-AL devices
offline.
2. Set the switch offline. For instructions, refer to
3. At the Element Manager application (management server), select
Backup & Restore Configuration from the Maintenance menu. The
Backup and Restore Configuration dialog box displays
4. Click Restore. A Warning dialog box displays, indicating the
existing configuration file is to be overwritten.
5. Click Yes. A Restore dialog box displays, indicating the restore is in
progress.
6. When the operation finishes, the Restore dialog box displays a
Restore complete message. Click Close to close the dialog box.
When configuration data is reset to factory default values, the switch
defaults to the factory-set (Internet Protocol) IP address and all
optional features are disabled. To reset configuration data to factory
default settings:
(Figure 64).
Set online state.
(Figure 64).