Table of Contents
Advertisement
— At a web browser communicating with the EFCM Basic
Edition interface, port failure information displayed at the
Hardware View, Port List View, or Event Log.
— At the management server (Element Manager application),
port failure information displayed at the Hardware View, Port
List View, Port Properties dialog box, or Event Log.
4. Block communication to the port. Refer to
(EFCM Basic Edition) or
application) for instructions.
5. Ensure an ESD grounding cable is connected to the product
chassis (or approved bench ground) and your wrist.
6. Disconnect the fiber-optic jumper cable from the port:
a. Pull the keyed LC connector free from the port's optical
transceiver.
b. Place a protective cap over the jumper cable connector.
7. The optical transceiver has a wire locking bale to secure the
transceiver in the port receptacle and to assist in removal. The
bale rotates up or down, depending on transceiver manufacturer
and port location (top or bottom row).
a. Disengage the locking mechanism by rotating the wire bale up
or down 90 degrees as shown in part (1) of
b. Grasp the wire bale and pull the transceiver from the port
receptacle as shown in part (2) of
Chapter 5: Removal and replacement procedures
Block or unblock a port
Block or unblock a port
(SAN management
Figure
Figure
69.
69.
203
Advertisement
Table of Contents
