Table of Contents
Advertisement
Task 4: Configure product at the EFCM Basic Edition interface
(optional)
26
SAN32M-2 Installation and Service Manual
8. After successful POST completion, the PWR LED remains
illuminated and all other front panel LEDs extinguish.
9. If a POST error or other malfunction occurs, go to
MAP
to isolate the problem.
10. Perform one of the following:
— If the switch is to be managed through the EFCM Basic Edition
interface, go to
Task 4: Configure product at the EFCM Basic
Edition interface
(optional).
— If the switch is to be managed through a management or
customer-supplied server, go to
network information
Perform these procedures to configure the product from the EFCM
Basic Edition interface. A browser-capable PC with Internet or
Ethernet LAN access is required. To open the interface:
1. Connect the Ethernet patch cable (supplied with the product) to
the RJ-45 connector (labelled 10/100) at the front panel.
2. Connect the remaining end of the Ethernet cable to the Internet or
LAN segment as directed by the customer. If the hub installed in
Task 2: Unpack, inspect, and install the Ethernet hub (optional)
provides connectivity, connect the cable to any available hub port.
3. At the PC, launch the browser application (Netscape Navigator or
Internet Explorer).
4. Enter the default Internet Protocol (IP) address of the switch
(10.1.1.10) as the uniform resource locator (URL). The Enter
Network Password dialog box displays.
5. Type the case-sensitive default user name (Administrator) and
password (password) and click OK. The First Time Login View
displays.
6. Type customer-specified values in the User Name, New Password,
and Confirm Password fields, then click Activate. The Topology View
displays with status information about each fabric element,
including the product to be configured.
Task 5: Configure product
(optional).
MAP 0000: Start
Advertisement
Table of Contents
